Thursday, February 04, 2016

Supported Extrusion 3D Printing

It’s been a busy week for architectural 3D printing news with several good options to discuss but one breakthrough stands above the others. I was quite happy to see the efforts of the Bartlett School of Architecture, UK, reported by 3ders.org in regards to their cementitious 3D printing achievements using a supported extrusion technique. This method begins with the placement of a cementitious material by a robotic head unit similar to that which is used by other firms but differentiates itself by simultaneously laying down a granular support material. After manufacturing once removed the process leaves a distinctive pattern the designers call “Fossilized” and I call “circuit board”. The process represents progress toward refining cementitious 3D printing technology by allowing for smaller detail tolerances. Unoforunately factors such as the process’s structural strength and long-term performance are still underreported and therefore a certain amount of skepticism is still warranted before calling this technology useful architectural 3D printing. I also question the qualifications of a group of designers to tackle what is essentially a mechanical engineering problem. Absolutely their design aesthetic is beyond reproach but where are they getting expertise in process, control, chemical and mechanical engineering? Food for thought at this technology continues to improve.    

Agree? Disagree? Share your comments below.                                                                                   

No comments: